The Jeep Liberty compact SUV has been produced by the Jeep division of Chrysler since 2002. This popular SUV comes equipped with a factory stereo and speakers. If you're an audio enthusiast who wants better sound in your Liberty, one of the best and most cost-effective upgrades is replacing the original factory speakers with higher-performance after-market models.
Instructions
Replacing the front door speakers
1. Locate the Phillips screw in the bottom of the door pull cup and remove it with your Phillips screwdriver.
2. Remove the screw cover (a small plastic piece) in the center of the door release. Take out the Phillips screw that's underneath it with your Phillips screwdriver.
3. Pry the door panel loose from the clips that hold it in place with your panel tool. Start at the edge and work your way around the door panel until the panel is loose, the lift the panel away from the door proper.
4. Take out the screws holding the speaker in place, then disconnect the wiring.
5. Connect the new speaker, mount it in place with the screws, and then reassemble the door panel.
Replacing the rear door speakers
6. Pry off the screw cover located in the center of the door release trim. Take the screw out with your Phillips screwdriver.
7. Locate the screw in the bottom of the door pull cup and take it out with your phillips screwdriver.
8. Use your panel tool to pry the door panel loose from the clips that hold it in place. Work all the way around the perimeter of the door to work it loose. Pull the door panel away from the door when it's loosened completely.
9. Unscrew the old speaker with your Phillips screwdriver and disconnect it.
10. Connect the new speaker and mount it in place with the screws. Reassemble the door panel.
Tags: door panel, with your, your Phillips screwdriver, panel loose, Phillips screwdriver