A stun device lets you protect your home from an unwanted invader without the fear of causing lethal damage. You can make a pair of stun gloves that will deliver a shock to the person who has broken into your home. You will need a few supplies from a hardware store, disposable flash film cameras from a drugstore and expertise in using a soldering iron. The stun gloves will work to incapacitate the invader without causing permanent damage. Because the use of a stun gun or any stun device is banned in some states, you must check with your local law enforcement or city council to verify whether you can legally use the stun gloves.
Instructions
1. Put a sheet of newspaper on a table. Put one of the disposable flash film cameras on the newspaper with the lens facing up. Release the tabs holding the front case of the disposable flash film camera to the back case with the flat-edged screwdriver. Remove the front case from off of the back case of the disposable flash film camera.
2. Remove the film cartridge from inside of the back case of the disposable flash film camera. Dispose of the film cartridge. Remove the battery from inside of the disposable flash film camera. Place the battery aside.
3. Drill two holes in the side of the back case of the disposable flash film camera that is next to the silver cylindrical capacitor on the circuit board.
4. Cut two 4-inch long strips of electric wire using the wire cutters. Strip a half inch of the insulation off of both ends of the two electric wires using the wire strippers.
5. Solder one of the ends of one of the two electric wires to one of the two contacts on the top of the silver cylindrical capacitor. Let the solder cool for a minute.
6. Solder one of the ends of the other electric wire to the other contact on the top of the silver cylindrical capacitor.
7. Push the free ends of the two wires through the two holes you have made in the side of the back case.
8. Wrap the free end of one of the electric wires around the base of a metal screw. Push the metal screw into one of the two holes in the side of the back case. Apply bonding glue around the hole. Let the bonding glue set for an hour.
9. Wrap the free end of the other electric wire around the base of a metal screw. Push the metal screw into the other hole in the side of the back case. Apply bonding glue around the hole. Let the bonding glue set for an hour.
10. Put the battery back into its position on the circuit board. Close the front case over the back case. Push the front case down firmly so that the tabs engage to hold the two parts of the disposable flash film camera together.
11. Put the left insulated glove inside of the left work glove. Place the work glove on the newspaper with the palm facing up.
12. Apply bonding glue to the back of the disposable flash film camera. Place the back of the disposable flash film camera against the palm of the work glove. Let the bonding glue set for a day.
13. Repeat the entire process of making a stun glove using the other disposable flash film camera and the right work glove.
14. Put on the pair of work gloves. Wind the film advance of each disposable flash film camera using the thumb of the other hand. Wait for the yellow or white LED to illuminate. Touch the metal screws on either or both work gloves against an intruder to deliver a shock from the stun gloves you have made.
Tags: disposable flash, disposable flash film, flash film, film camera, flash film camera
